Edge Angles & Wax Data

Manufacturers wax melting points
    The melting point of the p-tex base material is approx 150*C, and theepoxy resins used to construct skis and boards is about 170*C so youcan see that there's not much leeway between melting the wax & meltingthe bases! The key therefore is to keep the iron moving & don't leave it on the ski while you answer the phone!   Dominator                                                                                                                                                                                                                  X-Cold Waxes & Overlays   DOM-FX01, FX04, FX07, FG07, Q 250*F (120*C) Cold Waxes   DOM-FX11, FX44, FX77, FG77, HX77L, SRB11 230*F (110*C) Mid-range Wax & Overlays... Read more...
Ski Manufacturers edge angle specifications
MAKE/MODEL: BASE EDGE ANGLE, SIDE EDGE ANGLE   This information is based upon factory published specs or the angles I've measure when prepping new skis. However the angles should always be checked before tuning any skis for the first time. Armada:All models: 1,1 (Source: Tyson Hall, Armada Skis)   Amplid:All models: 0,0 (Email from Anian Thrainer of Amplid - which is scary as they're actually 1,1. A zero base edge angle would be unskiable!)   Atomic:All models: 1,3   Black Crows:https://support.black-crows.com/hc/en-us/articles/12380419076626-what-are-the-tuning-specs-of-my-skis-   Black Diamond:All models: 1,2 (Source: Brad Curkendall, Black... Read more...